Regenerative and Disc Braking used to stop the EV: Controlled through the Electronic Differential Motor Controller(EDMC): EV004:

Regenerative and Disc Braking

Regenerative Braking starts in some EVs when the driver eases off the Gas pedal. But kicks in when the Brake pedal is applied, and the drive motors go in reverse. The last stage requires the disc brakes to halt the Vehicle.

Checking Designs

Brake control system designs are checked using Matlab and Simulink design analysis tools. Service data will take time to collect and confirm the benefits. Mechanics doing servicing on EVs will notice the difference in the wear on the Disc Brakes.

Offer:

If you need help with research, fault-finding or writing documentation. Feel free to email or call me:

Contact:

ericsutherland@btws.co.uk

+44 (0)777 640 3252 

Skype: Eric.Sutherland1

#EVs, #Regenerative Braking, #Gas pedal, #Driver, #Brake pedal, #drive motors, #disc brakes, #Vehicle, #Brake control system designs, #Matlab, #Simulink, #design analysis tools, #Service data,

Motors & Generators on each Wheel: The Electronic Differential Motor Controller controls a motor controller on each wheel: EV002:

 

Motors & Generators on each Wheel

Normal Setup:

To ensure the correct response from the driver using the Steering Wheel and the Gas pedal. To enable relating to vehicles with engines. Drivers will notice the difference between two and four wheel driving.

Adding Generators:

A generator on each wheel to charge the on-board Battery and extend the range of the EV.

With Battery status detected to switch off the Generators, until the Battery is down to 40%.

Charging Data:

Data collected to set the recharging level for the type of Battery versus usage. 

Offer:

If you need help with research, fault-finding or writing documentation. email or call me:

Contact:

ericsutherland@btws.co.uk

+44 (0)777 640 3252

Skype: Eric.Sutherland1

#EVs, #Driver, #Steering Wheel, #Gas pedal, #two and four wheel driving, #generator on each wheel, #charge the on-board Battery, #extend the range of the EV, #Battery status detected to switch off the Generators, #Battery down to 40%, #Data collected to set the recharging level for the type of Battery versus usage,